...
In the Project Schematic of the Workbench window, right click on Geometry and select Properties . You will see the properties menu on the right of the Workbench window. Under Advanced Geometry Options , change the Analysis Type to 2D.
...
newwindow | ||||
---|---|---|---|---|
| ||||
https://confluence.cornell.edu/download/attachments/111221570/ScreenOrientation.PNG |
At this point, ANSYS Design Modeler DesignModeler will open in a new window. You will be asked to select the desired length unit. Use the default meter unit and click OK .
...
Note |
---|
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler. |
Start by creating a sketch on the XYPlane . Under Tree Outline , select XYPlane , then click on Sketching right before Details View . This will bring up the Sketching Toolboxes .
...
In the Sketching toolboxes, select Rectangle . Hover the cursor near the origin until you see a letter P. This means the cursor is coincident with a point, in this case the origin . Then drag the cursor to draw a rectangle.
Note: You do not have to worry about dimensions for now, we will specify them properly in the later step.
...
Dimensioning of the geometry is shown below:
Under Details View on in the lower left corner, input the value for dimension appropriatelyvalues for the appropriate dimensions. Then hit enter each time each dimension is entered.
V1: 0.0294 m
H2: 1.83 m
H3: 4.27 m
H4: 6.045 m
...
Now that we have the sketch done, we can create a surface for this sketch.
Then click on the Concept tab in the Design modeler DesignModeler window, then click on Surface from sketches .
...
newwindow | ||||
---|---|---|---|---|
| ||||
https https://confluence.cornell.edu/download/attachments/111221570/create+surface.gif |
...