Include Page |
---|
| ANSYS Google Analytics |
---|
| ANSYS Google Analytics |
---|
|
Include Page |
---|
| Bike Crank (Part 2) - Panel |
---|
| Bike Crank (Part 2) - Panel |
---|
|
Geometry
In this section, we will go into DesignModeler, the geometry engine, to sketch each gauge of the rosette on the front face of the crank. We will then create surfaces for each gauge from the sketch. We first need to define a new coordinate system, as shown in the video below.
Wiki Markup |
---|
{html}<iframe width="600" height="338" src="//www.youtube.com/embed/Jz3PE_G9t6g?rel=0" frameborder="0" allowfullscreen></iframe>{html} |
We then draw our first gauge and give it the proper dimensions.
Wiki Markup |
---|
{html}<iframe width="600" height="338" src="//www.youtube.com/embed/d7xckfS0Y-w?rel=0" frameborder="0" allowfullscreen></iframe>{html} |
This video will show you how to insert a midpoint which will be helpful to place the gauges at their correct locations. We will also show you how to copy your gauge to make the other two.
Wiki Markup |
---|
{html}<iframe width="600" height="338" src="//www.youtube.com/embed/Ty58XJU-RYU?rel=0" frameborder="0" allowfullscreen></iframe>{html} |
With the midpoints correctly defined and being static relative to the gauges, we specify their distances in the coordinate system centered at the front face of the support hole.
Wiki Markup |
---|
{html}<iframe width="600" height="338" src="//www.youtube.com/embed/htaZ7v1ZlKU?rel=0" frameborder="0" allowfullscreen></iframe>{html} |
Finally, we orient the gauges and create surfaces from the sketch.
Wiki Markup |
---|
{html}<iframe width="600" height="338" src="//www.youtube.com/embed/MQiaJtIO-eo?rel=0" frameborder="0" allowfullscreen></iframe>{html} |
Go to Step 3: Mesh
Go to all ANSYS Learning Modules