...
At this point we are interested in extracting the temperature values along the horizontal line, y=1m. First, (Right Click) Model > Insert > Construction Geometry as shown below.
newwindow |
---|
| Click Here for Higher Resolution |
---|
| Click Here for Higher Resolution |
---|
|
https://confluence.cornell.edu/download/attachments/146918520/InsConstructGeomFull.PNG |
Next,
(Right Click) Construction Geometry > Insert > Path as shown in the following image.
newwindow |
---|
| Click Here for Higher Resolution |
---|
| Click Here for Higher Resolution |
---|
|
https://confluence.cornell.edu/download/attachments/146918520/InsertPath_Full.PNG |
Then, set
Number of Sampling Points to 100, set
Start X Coordinate to 0, set
Start Y Coordinate to 1, set
End X Coordinate to 1, and set
End Y Coordinate to 1 as shown below.
Image Addednewwindow |
---|
| Click Here for Higher Resolution |
---|
| Click Here for Higher Resolution |
---|
|
https://confluence.cornell.edu/download/attachments/146918520/PathDet_Full.PNG |
Save
Save the project now. Do not close Mechanical.
Go to Step 7: Verification and Validation
See and rate the complete Learning Module
Go to all ANSYS Learning Modules