SimCafe

Space shortcuts

Child pages
  • Flat Plate Boundary Layer - Mesh

Versions Compared

Old Version 55

changes.mady.by.user user-ab9f4

Saved on

compared with

New Version 56

changes.mady.by.user user-ab9f4

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Here, the edges of the geometry will be given names so one can assign boundary conditions in Fluent in later steps. The left side of the pipe geometry will be called "Inletinlet" and the right side will be called "Outletoutlet". The top side of the rectangle will be called "PipeWallfar_field" and the bottom side of the rectangle will be called "CenterLineplate" as shown in the image below.
Image Removed
Image Added

newwindow
Click Here For Higher Resolution
Click Here For Higher Resolution
https://confluence.cornell.edu/download/attachments/8562404590737915/NamingNamedSelectionsNames_Full.png


In order to create a named selections first (Click) Edge Selection Filter, . Then click on the left side of the rectangle and it should highlight green. Next, right click the left side of the rectangle and choose Create Named Selection as shown below.

Image Modified

Select the left edge and right click and select Create Named Selection. Enter Inlet "inlet" and click OK. Under Outline, you will see the name Inlet under Named Selections.
Then,type "Inlet" into the text prompt and press ok as shown below.



Now, create named selections for the remaining three sides and name them according to the diagram.

...

First save the project. Next, close the Mesher window. Then, go to the Workbench Project Page and click the Update Project button, Image Modified.


Go to Step 4: Setup (Physics)