Startup

A few words on the formatting on the following instructions:

1. Notes that require you to perform an action are colored in blue

2. General information is colored in black, but does not require any action

3. Words that are bolded are labels for items found in ANSYS AIM

4. Most important notes are colored in red

Now that we have the pre-calculations, we are ready begin simulating in ANSYS AIM. Open ANSYS AIM by going to Start > All Apps > ANSYS 18.1 > ANSYS AIM 18.1. Once you are at the starting page of AIM select the Fluid Flow template as shown below.

Units

In the upper left corner, select Home > Units > U.S. Engineering. The units will now match the ones given in the problem specification.

Go to Step 2: Geometry

Go to all ANSYS AIM Learning Modules