Author: Keith Works, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Model Setup
5. Numerical Solution
6. Numerical Results
7. Verification & Validation
Rat Femur
Created using ANSYS 2019 R2
Under Construction
Problem Specification
Consider the bone model shown in the figure below. The geometry was obtained using a CT scan. The model is in compression. Additionally, assume the femur has a Young's Modulus of ?? GPa and a Poisson Ratio of ??. Using ANSYS, calculate the following:
??
Summary of steps used in this tutorial can be downloaded here.