Sign-up for free online course on ANSYS simulations!
Author: Jingsi Wu, Cornell University
Problem Specification
1. Pre-Analysis & Start-Up
2. Geometry
3. Mesh
4. Physics Setup
5. Numerical Solution
6. Numerical Results
7. Verification & Validation
Exercises
Comments
In order to do this exercise, you must have Ansys Composite Prepost installed.
All video tutorials contain audio instructions
Modal Analysis of a Composite Monocoque
Created using ANSYS 14.0
Problem Specification
One of the important measure in race car design is torsional stiffness. To obtain that specification, a twist test must be performed on the chassis. The figure below shows a simplified version of a race car chassis with a composite monocoque and two front suspension links. To simulate a twist test, the back of the monocoque will be fixed while coupling will be applied to the end of the two front suspensions.
One of the beauty of composite material is to customize the ply lay-ups to achieve optimum properties according to the needs. It is often the case where different ply lay-ups are used at different monocoque regions for their specific needs. This exercise has 4 different regions as shown in the above diagram. Details of the composite layup will be explained during the exercise.
We will find find torsional displacement using ANSYS. From this, torsional stiffness will be calculated using the following equations:
