You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »

Spacecraft Assembly with Bolted Flange 

Created using ANSYS 16.1

 

This module is under construction

Learning Goals

In this tutorial, you will learn to:

  • Build a nonlinear finite-element model to analyze a bolted assembly 
  • Model contacts between parts in an assembly
  • Model thermal strains
  • Model temperature-dependent material properties
  • Verify the finite-element model by refining the mesh and also comparing with hand calculations

Problem Specification

The Saturn V rocket that carried people to the moon is the most powerful machine ever built.  Watch this awe-inspiring video to get a sense of the tremendous power packed into this rocket. The Saturn V's first stage was powered by five F1 engines. In this exercise, we analyze the bolted flange joint that connected the mid and lower parts of the F1 engine nozzle. The image below shows a picture of the F1 engine and the corresponding model in ANSYS. Note that the ANSYS model includes only the mid and lower parts of the nozzle and the bolted flange joint connecting them. 

Below is close-up view of the bolted flange joint connecting the mid and lower parts of the nozzle.

We'll analyze this bolted joint by building a non-linear finite element model in ANSYS. Our main objective is to assess the margin of safety of the flange bolts. We'd also like to determine the separation between the jointed parts. 

The pressure due to the exhaust gas in the nozzle is calculated using 1D gas dynamics. It is assumed to vary linearly along the nozzle axis. The regeneration channels are omitted in the model. In exchange, a free body diagram is used to deduce the equivalent forces on the mid nozzle and lower nozzle (the upper nozzle is not modeled here).  This force pair is modeled as two separate forces. Thermal strain due to the hot gas and the bolt pretension are included in the model.

The video above <<<link>>> discusses the calculation of model inputs. The details of the load calculations are provided in this Excel file <<<link>>>.


Go to Step 1: Pre-Analysis & Start-Up

Go to all ANSYS Learning Modules

  • No labels