Tube Flocculator Construction History
Original Construction, Configuration and Modifications
The tube flocculator was constructed in the summer of 2008. To prevent flocs from settling in the tube flocculator was arranged in a vertical figure-eight. The flocculator has the same configuration and dimensions as the lab flocculator.
The flocculator was originally made of soft flexible clear tubing. The tubing was pinched as coiled along the flocculator. Additionally, the tubing degraded at the joints (See figure:....................) Air leaked into the tube at each of the bulkhead fittings. This air prevented flow through the flocculator. The plant operators advised using a thicker, more resistant tubing to solve the problem of degradation.
One attempted solution to this problem was to reconstruct the flocculator out of rigid tubing. The tubing was opaque and could not be forced into a figure eight configuration.
Finally, clear braid-reinforced tubing was used to set up the flocculator. This tubing was flexible enough to form a figure eight and very durable. The flocculator was set up vertically at ground level. Elevation differences between the flocculation tank and the outlet of the tube flocculator drive flow through the tube flocculator. A T with one end open to the atmosphere was connected to the outlet. The T can be elevated or lowered to control the flow rate through the flocculator.
Issues
Raw water particles were settling out in the 1/4 diameter line drawing water from the flocculation tank. The incoming NTU to the line was 8.2 NTU while the effluent turbidity was 4.9 NTU. It is presumed that particles were settling because no flocs were seen in the effluent. In the future the sampling line should be shortened to avoid this issue. The flocculator could be set up closer to the floc tank. Another option would be to measure raw water turbidity from the point which water enters the flocculator.
Data Collection
FReTA was constructed by the lab tube floc team for the plant and can be used in future semesters. FReTA measures the rate of change in turbidity as opposed to just measuring the turbidity at a specific point in the flocculator. This is advantageous because the the change in turbidity rate is comparable to the settling velocity.
Troubleshooting
air in the tube flocculator
Air often gets caught in the connection between the 1/4 line drawing water from the tank. To resolve this issue the peristaltice pump used to sample from the sed tanks was used to provide pressure to remove air. Additionally the joint was sealed with tape to make it air tight.
For additional information on flocculator issues see Flocculator Maintenance