Linear Orifce Flow Meter
Objective
To create an automated flow control device to add Alum and Chlorine to the raw water as a function of flow rate through the plant.
Automated Flow Control goals and meeting minutes
Fall 2008 Information
Goals
Teach-in Presentation.
Spring 2008 Information
Wiki Map
Initial Design
Experimental Data
Pictures and Graphs
Results
Conclusions
Future Research
Scientific Paper Rough Draft
Past Research
Abstract
Introduction
Design
Results and mathcad files
Conclusions
put in minutes later
Linear Orifice Flow Meter Miuntes 9/11/08
*earlier in the week we met with david railsback to go over his visions for how the project should progess as well as gain his insight into the project. At the time the summer team hadn't given us their information so we didn't have much specifically to about. I gave him an update on the progress made with the linear orifice flow meter spring 2008 and showed him the results. We plan on meeting again later when we are caught up.
*Discussed the work done during summer 2008. they created a prototype of the lever arm for chemical dosing and nicole walked me through how their set-up works. We briefly talked about where we thought improvements could be made: stonger connecting medium (curretly fishing wire), thinner float so it will fit into the entrance tank, and stable support mechanism for the flow control modules.
*We also worked on combingin our goals page, which we later found out was wrong and we should have two seperate pages.