Creating the Geometry for the Bolted Nozzle Flange

Created using ANSYS 16.2

Learning Goals

In this tutorial, you will learn how to create the geometry used for the Bolted Nozzle Flange problem, presented in Module 3 of the Cornell's Engineering Simulations MOOC on edx.org. (LINK)

Problem Specification

Check Module 3 of the MOOC

Geometry Creation

The step on how create the geometry are shown in the following videos.

Specifying the Contact Regions

Go to Step 1: Pre-Analysis & Start-Up

Go to all (ANSYS or FLUENT) Learning Modules