Author: John Singleton and Rajesh Bhaskaran, Cornell University
Problem Specification
1. Pre-Analysis & Start-up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation
Under Construction
This page of this tutorial is currently under construction. Please check back soon!!!!!!!!!!!!!!
Useful Information
Click here for the FLUENT 6.3.26 version.
Step 5: Solution
Second Order Scheme
A second-order discretization scheme will be used to approximate the solution. In order to implement the second order scheme click on Solution Methods then click on Momentum and select Second Order Upwind as shown in the image below.
Set Convergence Criteria
FLUENT reports a residual for each governing equation being solved. The residual is a measure of how well the current solution satisfies the discrete form of each governing equation. We'll iterate the solution until the residual for each equation falls below 1e-6. In order to specify the residual criteria (Click) Monitors > Residuals > Edit..., as shown in the image below.
Next, change the residual under Convergence Criterion for continuity, x-velocity,and y-velocity, all to 1e-6, as can be seen below.
Lastly, click OK to close the Residual Monitors menu.
Set Initial Guess
Here, the flow field will be initialized to the values at the inlet. In order to carry out the initialization click on Solution Initialization then click on Compute from and select inlet as shown below.
Then, click the Initialize button, . This completes the initialization process.
Execute Calculation
Prior, to running the calculation the maximum number of iterations must be set. To specify the maximum number of iterations click on Run Calculation then set the Number of Iterations to 100, as shown in the image below.
As a safeguard save the project now. Now, click on Calculate two times in order to run the calculation. The residuals for each iteration are printed out as well as plotted in the graphics window as they are calculated. After running the calculation, you should obtain the following residual plot.
The residuals fall below the specified convergence criterion of 1e-6 in about 48 iterations, as shown below. Actual number of convergence steps may vary slightly.
At this point, save the project once again.
Go to Step 6: Results
See and rate the complete Learning Module
Go to all FLUENT Learning Modules