Sedimentation Tanks

Abstract

For the Four Communities plant the depth of the two sedimentation tanks was reduced by almost half a meter from 2 meters to 1.55 meters to cut construction costs. The tanks were designed to accommodate a floc blanket to improve effluent quality. No concrete evidence of a floc blanket had been seen before the study. One tank was shut off in an attempt to form a floc blanket. Additionally the effluent water turbidity was compared to the settled water turbidity at the end of a tube settler to determine if the sedimentation tanks were working efficiently.

Floc Blanket Research

The upflow velocity in one of the sedimentation tanks was increased an attempt to form a floc blanket.

[Sedimentation Tank Efficiency]

The settled water turbidity at the end of the flocculator was compared to the effluent water quality

Conclusions

-At low turbidities most flocs may not be reaching the tank
-It would be advantageous to run the floc blanket test again when the incoming turbidity to the plant is higher. Given that there were no flocs initially rising in the tank as had been previously observed, and the clarity of the water below the lamella is highly probable that most flocs were settling out before they reached the sedimentation tanks in this test. With more flocs in the tank it might be possible to form a floc blanket. However, it would be impractical to expect that a floc blanket could be maintained without increasing the amount of flocs that reach the sedimentation tanks at low incoming turbidities.
-Efficiency