Problem Specification
1. Start-up and preliminary set-up
2. Specify element type and constants
3. Specify material properties
4. Specify geometry
5. Mesh geometry
6. Specify boundary conditions
7. Solve!
8. Postprocess the results
9. Validate the results
...
There is good correlation of the edge stress on the bottom of facesheet but the edge stress at the top of the stiffeners is overestimated by the theory. This is possibly due to the stiffeners not being at the centerline of the model while the maximum stresses in theory are calculated at the center.
Back to Problem Specification
Copyright 2006. |
...