Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Panel

Problem Specification
1. Start-up and preliminary set-up
2. Specify element type and constants
3. Specify material properties
4. Specify geometry
5. Mesh geometry
6. Specify boundary conditions
7. Solve
8. Postprocess the results
9. Validate the results

Step 1: Start-up and preliminary set-up

Create a folder

Create a folder called contact at a convenient location. We'll use this folder to store files created during the ANSYS session.

Start ANSYS

Start > Programs > ANSYS 7.1 > Configure ANSYS Classic

Enter the location of folder contact as your Working directory.

Specify diskscontact as your Initial jobname. Click on Run.
Resize the ANSYS windows as shown in this screen arrangement so that you can read instructions in the browser window and implement them in ANSYS.

Set Preferences

Main Menu > Preferences

In the Preferences for GUI Filtering dialog box, click on the box next to Structural so that a tick mark appears in the box. Click OK.

Recall that this is an optional step that customizes the graphical user interface so that only menu options valid for structural problems are made available during the ANSYS session.

Enter Parameters

For convenience, we'll create scalar parameters corresponding to the principal radii of curvature of the upper and lower disks R1, R1', R2 and R2', load p, material properties E, n=nu and the initial interference between the disks, inter.

...

Enter the parameter value for R1:
R1=60
Click Accept.

Similarly, enter the other parameter values and click Accept after each.

R1p=130
R2=80
R2p=200
inter=1e-5
p=4500
E=2e5
nu=0.29

 
Close the Scalar Parameters window. Note that we have specified the radii in mm, the load p in N and the Young's modulus in N/mm2. Therefore, the displacement results we obtain will be in mm and the stresses in N/mm2.

...

Go to Step 2: Specify element type and constants

Go to all ANSYS Learning Modules