Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Include Page
ANSYS Google Analytics
ANSYS Google Analytics
Include Page
Panel - ANSYS AIM Forces in Permanent Magnets
Panel - Panel ANSYS AIM Forces in Permanent Magnets - Panel

Case Setup

Setting up case 1:

The last parameter we need to define is the force on the magnet. Go to Results in the workflow. Under Objects, click on Results again. Select Value Force Magnitude 1. Click on the arrow horizontal from undefined and select parametrize.

Image RemovedImage Added

Click on the Design Points dashboard in the upper right hand corner.  

Image RemovedImage Added

The first table that comes up is the design points.  Under Current 1 Operating current, iterate the input by 10 mA up to 100mA. Use the image below for reference.  In the other column, input 0.254mm for the horizontal(R) distance.  Once this is done, click Update All in the top right corner of the design points dashboard. AIM will solve each case for the force on the magnet and the force outputs for each current input can be seen in the design points dashboard.

Image RemovedImage Added


Setting up case 2:

In case two, the force of the magnetic is a function of horizontal(R) distance. In the design parameters dashpoint, change all the current data points to 50mA. Then iterate the horizontal data points from 0.05mm-.5mm by 0.05mm. Click update all to see results.  

Image RemovedImage Added

 

Go to Step 5: Solution/Results

Go to all ( ANSYS or FLUENT) AIM Learning Modules