Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Include Page
ANSYS Google Analytics
ANSYS Google Analytics
Include Page
Panel - ANSYS AIM Forces in Permanent Magnets
Panel - Panel ANSYS AIM Forces in Permanent Magnets - Panel

Pre-Analysis & Start-Up

Pre-Analysis

In the Pre-Analysis step, we'll review the following:

  • Mathematical model: (e.g.: We'll look at the governing equations + boundary conditions and the assumptions contained within the mathematical model.)
  • Numerical solution procedure in ANSYS: (e.g.: We'll briefly overview the solution strategy used by ANSYS and contrast it to the hand calculation approach.)
  • Hand-calculations of expected results: (e.g.: We'll use an analytical solution of the mathematical model to predict the expected stress field from ANSYS. We'll pay close attention to additional assumptions that have to be made in order to obtain an analytical solution.)

Mathematical Model 

Note

Under Construction

Numerical Solution Procedure in ANSYS

Note

Under Construction

Hand-Calculations of Expected Results

Note

Under Construction

Start-Up

Note

Under Construction

Governing Equation

Magnetostatics is the study of magnetic fields in devices where the magnetic field is generated from DC (steady) currents and/or permanent magnets.  Magnetostatics is a special case of Maxwell’s equations, which form the basis of electromagnetism.  

For magnetostatics the electric field inside of a current carrying coil is completely decoupled from the magnetic field, and the following Maxwell’s equations are solved for magnetostatics -

  Image Added

Where ∇ denotes divergence, H is the magnetic field intensity, J is the current density, and B is the magnetic flux density.


Start Up

A few words on the formatting on the following instructions:

  1. Notes that require you to perform an action are colored in blue

  2. General information will be colored in black, but do not require any action

  3. Words that are bolded are labels for items found in ANSYS AIM

  4. Most important notes will be colored in red

Now that the the pre-calculations are finished, we are ready to begin the simulation in ANSYS AIM. Open ANSYS AIM by going to Start > All Apps > ANSYS 18.2 > ANSYS AIM 18.2. Once starting page has opened, select the Magnetics template as shown below.

Image Added


Go to Step 2: Geometry

Go to all ( ANSYS or FLUENT) AIM Learning Modules