Page History

...

1. Click on the streamline button and leave the name as velocity streamline
   1. Start from: click the 3 dots next to inlet and select inlet and outside inlet
   2. Change the number of points to 200
   3. Variable: Velocity in Stn frame
   4. In the color tab, change the range from global to user specified and put min=9m/s and max=13m/s. 
   5. Click Apply

...

Pressure

...

Contours

Next up, we'll look at the pressure distribution on the blade surface. 

...

1. Add contour, name it pressure contour
   1. Choose pressure
   2. Change # of contours to 110
   3. Go in render and uncheck lighting

...

Pressure Contours in the y-z Plane

To plot the pressure distribution at a cross section of the blade:

1. Make sure to have only 1 graphical instance of the blade
2. Create a plane
   1. Select 'Location' > 'Plane'
   2. Set method to YZ plane
   3. Set X to desired value (Note that blade is in -x direction) 
   4. Click Apply
3. Adjust view
   1. Click +X on the bottom right triad
4. Create a pressure contour
   1. Select 'Create chartInsert' > 'Contour'
   2. Set location to the plane just created
   3. Make sure the variable is pressure
   4. Specify min and max values to show high/low pressure regions
   5. Go under the 'view' tab and check 'apply rotation'
      1. Set axis to X
      2. Set angle to 90 degrees

...

Pressure Contours along the z-axis

To plot the variation of pressure along the axis of rotation:

...