Page History

...

1. Make sure to have only 1 graphical instance of the blade
2. Create a plane
   1. Select 'Location' > 'Plane'
   2. Set method to YZ plane
   3. Set X to desired value (Note that blade is in -x direction) 
3. Adjust view
   1. Click +X on the bottom right triad
4. Create a pressure contour
   1. Select 'Create chart'
   2. Set location to the plane just created
   3. Make sure the variable is pressure
   4. Specify min and max values to show high/low pressure regions
   5. Go under the 'view' tab and check 'apply rotation'
      1. Set axis to X
      2. Set angle to 90 degrees

...

1. Create a line to represent the z-axis (axis of rotation) 
   1. Select 'Location' > 'Line'
   2. Name it 'AxisRotation'
   3. Set Point 1 to (0,0,90)
   4. Set Point 2 to (0,0,-180)
   5. Change # of samples to 200
2. Create a chart
   1. Select 'Create chart'
   2. Under 'data series', create a new data series
   3. Set location to the line 'AxisRotation'
   4. Under 'x axis', set variable to Z 
   5. Check 'invert axis' because wind is traveling in -Z direction
   6. Under 'y axis', set variable to Pressure

...