Sign-up for free online course on ANSYS simulations!| Include Page | ||||
|---|---|---|---|---|
|
| Include Page | ||||
|---|---|---|---|---|
|
...
The following video shows how to make a plot of the Mach number contours using CFD Post. If the videos below don't appear in your browser, try reloading the webpage
| Wiki Markup |
|---|
{html |
}<iframe width="600" height="338" src="//www.youtube.com/embed/cZpjpNbxXYM" frameborder="0" allowfullscreen></iframe>{html} |
| Note |
|---|
To properly send the additional quantities to CFD post, you need to do the following steps in the right order. First initialize your solution, then select the additional quantities as shown in the above video and finally, run the calculation. |
...
The following video shows how to make a plot of the pressure contours.
| Wiki Markup |
|---|
{html |
}<iframe width="600" height="338" src="//www.youtube.com/embed/uPfpFds_JpQ" frameborder="0" allowfullscreen></iframe></iframe>{html} |
Velocity Vectors
To plot the velocity vectors, follow the steps in the video below.
| Wiki Markup |
|---|
{html |
}<iframe width="600" height="338" src="//www.youtube.com/embed/sTm_G4W7ujQ" frameborder="0" allowfullscreen></iframe>{html} |
Plot Mach Number Variation Along y=0.4 m
First, we'll create a line at y=0.4m. Then, we'll plot the Mach number variation along this line using the "Chart" facility in CFD Post. These steps are shown in the video below.
| Wiki Markup |
|---|
{html |
} <iframe width="600" height="338" src="//www.youtube.com/embed/tJMbrxn7Jzw" frameborder="0" allowfullscreen></iframe>{html} |
Go to Step 7: Verification & Validation
...