Page History

...

In order to make sure that the cross section was assigned to the solid body click on "View", then click on "Cross Section Solids" as shown below.


Then click on the little turquoise dot, , located by the axes in the bottom right portion of the screen. You should now see the the plane frame rendered in 3D as shown below.


At this point you can close the Design Modeler and you may want to save your project.

Exporting The Geometry

Note: This step needs to be done only in version 13.0. It can be skipped in version 14.0 and later.

In order to make sure to get the geometry data transferred to the Model a couple of steps must be taken. First, right click on "Geometry" then click on "Properties". Under "Properties of Schematic A3: Geometry" expand "Basic Geometry Options" and check the box to the right of "Line Bodies" as seen below.

...