Page History

...

Now, the geometry and the number of divisions need to be specified. First (Click) Edge Selection Filter,  Image Removed Image Added
, in the upper toolbar. Hold down the "Ctrl" button and then click the edges AF and BG. Both sides should highlight green. Next, hit Apply under the Details of Sizing table as shown below. 

...

First save the project in the Mesher window. Next, close the Mesher window. Then, go to the Workbench Project Page and click the Update Project button,  Image Removed Image Added
.

If the Progress window shows error message like this: "Model information is incompatible with incoming mesh", right click on Setup in the workbench and select "Reset", then Update Project again.

...