Include Page |
---|
...
|
Include Page | ||
---|---|---|
|
...
|
...
Geometry
...
Problem Specification
1. Pre-analysis & Start-up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation
8. Exercise
Note |
---|
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler. |
HTML |
---|
<iframe width="600" height="338" src="//www.youtube.com/embed/jumO-0sGhSw?rel=0" frameborder="0" allowfullscreen></iframe>
|
The unit used in this tutorial is SI (meters).
Go to Step 3:
Geometry
Go to Step 3 - Mesh