...

Step 6: Results

Please make sure your project is saved in Workbench. Double click on Results in the Project Schematic window. This will open CFD-Post (the program used to analyze results from FLUENT computation.)

Overview

You may have noticed in previous sections, that the pipe looks extremely long and thin on the screen. In fact, due to the axisymmetric assumption, we have only modeled half of a 2D section through the pipe in our analysis. To be able to make full use of the results, we must:

...

The  results shown below were obtained with a pipe length of 6.096 which is slightly different from the current length of 6.045. So your results might be slightly different from those shown below.

Temperature Contour

Our first challenge is the temperature contour. On the top menu, click on contour . We will be calling this contour "Temperature Contour", OK when done. On the left hand side, Details of Temperature Contour will allow you to select parameters relevant to the results we're looking for. In this example, the Locations is periodic 1, the Variable is Temperature. The number of contours is a personal preference, in this example, we have selected 100. This step tells CFD-Post we are looking to plot contours of temperature.

...

In developing the experiment, it was assumed that by the end of the adiabatic mixing stage, the flow will be well mixed. Do the results from the numerical solution simulation support this assumption?

Velocity Vectors

Our next challenge is to produce velocity vectors. This is a very similar process to creating the temperature contours above. On the top menu, click on vector . Name it "Velocity Vector" and click OK. Under Details of Velocity Vector, select periodic 1 for Locations. Select Velocity for Variable. This tells CFD-post we are looking for vector plots of velocity.

...

Finally click Apply. You will see that under Outline > User Locations and Plots, Velocity Vector is created. Un-check Temperature Contour so that Graphics window shows just the Velocity Vector plot. You can mirror the plot about the axis as before. You can translate the model to look at flow development near the entrance. There is a toolbar option at top that puts you in translate mode. You can click on the z-axis to restore our original view.

Image Added

Does the flow become fully developed at the end of the first section?

...