Page History

...

Panel
Problem Specification 1. Pre-analysis & Start-up 2. Geometry 3. Mesh 4. Setup (Physics) 5. Solution 6. Results 7. Verification & Validation

Results and Discussion

You may receive an warning that says "The initial time increment may be too large for this problem. Check results carefully." . Our initial time step is set to 36seconds, which is rather large for transient analysis. The warning can be eliminated by turning off Auto Time Stepping under Analysis Settings and manually specify the initial time step.

Go to Step 7 - Verification & Validation
Go to all ANSYS Learning Modules

Space shortcuts

Child pages

Versions Compared

Old Version 4

New Version 5

Key

Results and Discussion