For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler.

<iframe width="600" height="338" src="

{include: ANSYS Google Analytics}
{panel}
[Problem Specification|SIMULATION:ANSYS 13 - 3D Conduction Problem Specification]
[1. Pre-analysis|SIMULATION:ANSYS 13 - 3D Conduction - Pre-analysis]
*2. Geometry*
[3. Mesh|SIMULATION:ANSYS 13 - 3D Conduction - Mesh]
[4. Setup (Physics)|SIMULATION:ANSYS 13 - 3D Conduction - Setup (Physics)]
[5. Solution|SIMULATION:ANSYS 13 - 3D Conduction - Solution]
[6. Transient Setup (Physics)|SIMULATION:ANSYS 13 - 3D Conduction - Transient Setup (Physics)]
[7. Transient Solution|SIMULATION:ANSYS 13 - 3D Conduction - Transient Solution]
[8. Results|SIMULATION:ANSYS 13 - 3D Conduction - Transient Results]
7. Verification and Validation
Exercises
{panel}

h2. Step 2: Geometry

{composition-setup}
cloak.toggle.type = none
{composition-setup}
{widget:url=\[[http://www.youtube.com/watchembed/drIvq8Ker60?v=drIvq8Ker60&list=UU8bXUXdcNDyFTIp6YVrt|http://www.youtube.com/watch?v=drIvq8Ker60&list=UU8bXUXdcNDyFTIp6YVrt]\]\|width=600\|height=370}
 

\\
{widget:url=\[[http:rel=0" frameborder="0" allowfullscreen></iframe>

<iframe width="600" height="338" src="//www.youtube.com/embed/watch?v=XFVh1AeNDzU&list=UU8bXUXdcNDyFTIp6YVrt|http://www.youtube.com/watch?v=XFVh1AeNDzU&list=UU8bXUXdcNDyFTIp6YVrt]\]\|width=600\|height=370}

{cloak:id=cloaked}
Highlight each line of the above panel and insert the appropriate links to the other pages of your tutorial

Highlight the bold line at the bottom of the page that read "Go to Step...".  Insert the appropriate link to the next page of your tutorial.

Enter any relevant text, images, and videos in the space under where it says "cloak" below
{cloak}
\\


*[Go to Step 3: Mesh|SIMULATION:ANSYS 13 - 3D Conduction - Mesh]*
[Go to all ANSYS Learning Modules|SIMULATION:ANSYS Learning Modules]?rel=0" frameborder="0" allowfullscreen></iframe>