Versions Compared


  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Include Page
ANSYS Google Analytics
ANSYS Google Analytics
Include Page
Transient Conduction - Panel
Transient Conduction - Panel



For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler.

Create a 1m x 1m square in 2 dimensional space.

<iframe width="600" height="338" src="
Wiki Markup
{include: ANSYS Google Analytics}
*[Problem Specification|SIMULATION:Transient Conduction - Problem Specification]*
[1. Pre-analysis|SIMULATION:Transient Conduction - Pre-analysis]
*2. Geometry*
[3. Mesh|SIMULATION:Transient Conduction- Mesh]
[4. Setup (Physics) and Solution|Transient Conduction - Setup (Physics) and Solution]
5. Solution
[6. Results|SIMULATION:Transient Conduction - Results]
[7. Verification and Validation|SIMULATION:Transient Conduction - Verification and Validation]

h2. Step 2: Geometry

cloak.toggle.type = none
Highlight each line of the above panel and insert the appropriate links to the other pages of your tutorial

Highlight the bold line at the bottom of the page that read "Go to Step...".  Insert the appropriate link to the next page of your tutorial.

Enter any relevant text, images, and videos in the space under where it says "cloak" below
Create a 1m x 1m square in 2 dimensional space.

*[Go to Step 3: Mesh|SIMULATION:Transient Conduction- Mesh]*
[Go to all ANSYS Learning Modules|SIMULATION:ANSYS Learning Modules]vgA2itrWAAg" frameborder="0" allowfullscreen></iframe>

Go to Step 3: Mesh

Go to all ANSYS Learning Modules