For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler.

<iframe width="600" height="338" src="

{include: ANSYS Google Analytics}
{panel}
*[Problem Specification|SIMULATION:Transient Conduction - Problem Specification]*
[1. Pre-analysis|SIMULATION:Transient Conduction - Pre-analysis]
*2. Geometry*
[3. Mesh|SIMULATION:Transient Conduction- Mesh]
[4. Setup (Physics) and Solution|SIMULATION:Transient Conduction - Setup (Physics)]
5. Solution
[6. Results|SIMULATION:Transient Conduction - Results]
[7. Verification and Validation|SIMULATION:Transient Conduction - Verification and Validation]
Exercises
{panel}

h2. Step 2: Geometry

{composition-setup}
cloak.toggle.type = none
{composition-setup}
{cloak:id=cloaked}
Highlight each line of the above panel and insert the appropriate links to the other pages of your tutorial

Highlight the bold line at the bottom of the page that read "Go to Step...".  Insert the appropriate link to the next page of your tutorial.

Enter any relevant text, images, and videos in the space under where it says "cloak" below
{cloak}
Create a 1m x 1m square in 2 dimensional space.
{widget:url=http://www.youtube.com/embed/watch?v=vgA2itrWAAg&list=UU8bXUXdcNDyFTIp6YVrt|width=600|height=370}


*[Go to Step 3: Mesh|SIMULATION:Transient Conduction- Mesh]*
[Go to all ANSYS Learning Modules|SIMULATION:ANSYS Learning Modules]vgA2itrWAAg" frameborder="0" allowfullscreen></iframe>