For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler.

<iframe width="600" height="338" src="

{include: ANSYS Google Analytics}
{panel}
[Problem Specification|ANSYS - Stress due to Gravity]
[1. Pre-analysis|SIMULATION:Stress due to Gravity - Pre-analysis]
*[2. Geometry|SIMULATION:Stress due to Gravity - Geometry]*
[3. Mesh|SIMULATION:Stress due to Gravity - Mesh]
[4. Setup (Physics)|SIMULATION:Stress due to Gravity - Setup (Physics)]
[5. Solution|SIMULATION:Stress due to Gravity - Solution]
[6. Results|SIMULATION:Stress due to Gravity - Results]
[7. Verification and Validation|SIMULATION:Stress due to Gravity - Verification and Validation]
[Exercises|SIMULATION:Stress due to Gravity - Exercises]
{panel}

h2. Step 2: Geometry

{composition-setup}
cloak.toggle.type = none
{composition-setup}
{cloak:id=cloaked}
Highlight each line of the above panel and insert the appropriate links to the other pages of your tutorial

Highlight the bold line at the bottom of the page that read "Go to Step...".  Insert the appropriate link to the next page of your tutorial.

Enter any relevant text, images, and videos in the space under where it says "cloak" below
{cloak}
The following video will walk you through starting ANSYS and creating your geometry.
{widget:url=http://www.youtube.com/embed/watchFK0RZqmhsrE?v=FK0RZqmhsrE|width=600|height=370}


[*Go to Step 3: Mesh*|SIMULATION:Stress due to Gravity - Mesh]
[Go to all ANSYS Learning Modules|SIMULATION:ANSYS Learning Modules]rel=0" frameborder="0" allowfullscreen></iframe>