Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The subsequent calculations conducted for each trial determine both the minimum pressure required to trigger foam compression and maximum pressure to reach full compression. A full discussion of these calculations can be viewed in the Foam Compression (Physical) Test MathCAD file. Results from the five total experiments are discussed below.

Summary of Results

Ideally, the resulting min. and max. pressures for one piece of foam found from each of the trials should be the same. The pressure that triggers the beginning of compression and results in full compression should be the same for each sample of foam. However, as seen in the results in the table below, some discrepancies between pressure values do occur.

Write small commentary on summary of results (ex: any discrepancies between values, how much error, why did error occur, etc.).

...