...
Launch Mesher
(Double Click) Mesh
Mapped Face Meshing
(Right Click) Mesh > Insert > Mapped Face Meshing
Set Geometry to both portions of the surface body. You will have to hold down control in the selection process in order to highlight both halves. Click Update.
Circumferential Edge Sizing
(Right Click) Mesh > Insert > Sizing
Set Geometry to both edges of the surface body. You will have to use the edge selection filter and you will have to hold down control in the selection process in order to highlight both halves. Click Update.
Go to Step 4: Setup (Physics)
See and rate the complete Learning Module
Go to all FLUENT Learning Modules