Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Wiki Markup
{alias:pipe1}
{panel}
Author: Rajesh Bhaskaran, Cornell University

{color:#ff0000}{*}Problem Specification{*}{color}
[1. Pre-Analysis & Start-up|FLUENT - Laminar Pipe Flow Step 1]
[2. Geometry|FLUENT - Laminar Pipe Flow Step 2]
[3. Mesh|FLUENT - Laminar Pipe Flow Step 3]
[4. Setup (Physics)|FLUENT - Laminar Pipe Flow Step 4 *New]
[5. Solution|FLUENT - Laminar Pipe Flow Step 5 *New]
[6. Results|FLUENT - Laminar Pipe Flow Step 6 *New]
[7. Verification & Validation|FLUENT - Laminar Pipe Flow Step 7]
[Problem 1|FLUENT - Laminar Pipe Flow Problem 1]
[Problem 2|FLUENT - Laminar Pipe Flow Problem 2]
{panel}

h2. Problem Specification

!Fluent_pipeflow.jpg!

Consider fluid flowing through a circular pipe of constant cross-section. The pipe diameter _D_ = 0.2 m and length _L_ = 8 m. The inlet velocity _Ū{_}{_}{~}z{~}_ = 1 m/s. Consider the velocity to be constant over the inlet cross-section. The fluid exhausts into the ambient atmosphere which is at a pressure of 1 atm. Take density _ρ = 1 kg/ m{_}{_}{^}3{^}_ and coefficient         of viscosity _µ = 2 x 10{_}{_}^\-3{^}_ _kg/(ms)._ The Reynolds number _Re_ based on the pipe diameter is
{latex}
\large
$$
{Re} = {\rho {\bar{U}}_zD \over \mu} = 100
$$
{latex}
where _Ū{_}{_}{~}z{~}_ is the average velocity at the inlet, which is 1 m/s in this case.

Solve this problem using FLUENT. Plot the centerline velocity, wall         skin-friction coefficient, and velocity profile at the outlet. Validate         your results.

Note: The values used for the inlet velocity and flow properties are         chosen for convenience rather than to reflect reality. The key parameter         value to focus on is the Reynolds no.
\\
\\
Go to [Step 1: Pre-Analysis & Start-up|FLUENT - Laminar Pipe Flow Step 1]

[See and rate the complete Learning Module|FLUENT - Laminar Pipe Flow]

[Go to all FLUENT Learning Modules|FLUENT Learning Modules]