Page History

...

Parameters can be defined in SpaceClaim, even if the geometry was created in DesignModeler or another CAD software, as is the case for us. To do this, right-click on Image Modified from the Project Schematic window and choose "Edit Geometry in SpaceClaim..." as shown below:

...

Design Variables: Hole Radius (DesignModeler)

If This section applies only if you do not have access to SpaceClaim. In that case, we you can also use DesignModeler (the older geometry engine) to specify our your parameters. In order to do so, open DesignModeler by double-clicking on  from the Project Schematic window. Then expand XYPlane. Next, highlight Sketch1.

...