...
To set up the input and output parameters for a geometry created in Workbench, simply follow the steps below. To set up parameters for a geometry created in SolidWorks, follow the instructions here.
Design Variables: Hole Radius (SpaceClaim)
...
Design Variables: Hole Radius (DesignModeler)
If This section applies only if you do not have access to SpaceClaim. In that case, we you can also use DesignModeler (the older geometry engine) to specify our your parameters. In order to do so, open DesignModeler by double-clicking on from the Project Schematic window. Then expand XYPlane. Next, highlight Sketch1.
...