...

...

...

...

...

Physics Setup

...

Fix The Two Supports

...

 

Assign the Young's modulus. Apply the boundary conditions and make sure the structure is well-constrained to prevent motion in x,y,z. 

Widget Connector
width 560 url https://www.youtube.com/watch?v=dGuoDyLa4Ik height 315

Create The Two Point Loads

...

Create The Two Distributed Loads

The middle 2kN/m distributed load will be created first. Right click on "Static Structural", then click "Insert", then click "Line Pressure" as shown below.
Now, click on the line selection button, Image Removed , and select the lower horizontal line (it should highlight green). Then, click the apply button in the "Details of Line Force" box. Next, change "Define By" to "Components" as was done earlier. Set the y component to -2000N/m as shown below.
Image Removed
Now, repeat the process for the upper horizontal line.

Go to Step 5: SolutionSee and rate the complete Learning ModuleNumerical Solution

Go to all ANSYS Learning Modules