...

...

4. Setup (Physics)

Fix The Two Supports

...

Create The Two Point Loads

...

Physics Setup

Assign the Young's modulus. Apply the boundary conditions and make sure the structure is well-constrained to prevent motion in x,y,z. 

...

Create The Two Distributed Loads

The middle 2kN/m distributed load will be created first. Right click on "Static Structural", then click "Insert", then click "Line Pressure" as shown below.
Image Removed
Now, click on the line selection button,Image Removed , and select the lower horizontal line (it should highlight green). Then, click the apply button in the "Details of Line Force" box. Next, change "Define By" to "Components" as was done earlier. Set the y component to -2000N/m as shown below.
Image Removed

Go to Step 5: SolutionSee and rate the complete Learning ModuleNumerical Solution

Go to all ANSYS Learning Modules