...

...

...

...

...

Physics

...

Open the Model Window

...

Setup

...

Fix The Left Side of The Beam

...

Apply a Point Force to The Right Side of The Beam

...

Specify Young's Modulus

<iframe width="560" height="315" src="https://www.youtube.com/embed/SWRnNrWwrZU" frameborder="0" allowfullscreen></iframe>

Specify Boundary Conditions

<iframe width="560" height="315" src="https://www.youtube.com/embed/TIMyW47UHW0" frameborder="0" allowfullscreen></iframe>

Go to Step 5: Numerical Solution

...

Assign Cornellian to The Beam

The material Cornellian that was created earlier needs to be applied to the beam. In order to do so, expand Geometry, Image Removed. Next, click once on Line Body, Image Removed, which will appear underneath Geometry. Then expand "Material" which is located under "Details of "Line Body"". Then click on the arrow on the far right and change the specified material to Cornellian as shown below.
Image Removed
Leave the Setup window open for the next step.
Go to Step 5: SolutionSee and rate the complete Learning Module

Go to all ANSYS Learning Modules