Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Include Page

...

Cantilever Beam - Panel

...

Cantilever Beam - Panel
Include Page

...

ANSYS Google Analytics

...

ANSYS Google Analytics

...

Geometry

...

The following videos use the legacy geometry engine, DesignModeler. Please see this page of the EdX course for updated instructions using the new geometry engine, SpaceClaim.

Sketch the Midline

HTML
<iframe width="560" height="315" src="https://www.youtube.com/embed/Lm9Z_3eMAQc" frameborder="0" allowfullscreen></iframe>

Specify Moment of Inertia

HTML
<iframe width="560" height="315" src="https://www.youtube.com/embed/W_QGlwxIza0" frameborder="0" allowfullscreen></iframe>

Check Your Understanding

Select the correct option below.

Consider the case where we replace our square cross-section in ANSYS with a different cross-section that has a lower cross-sectional area but the same moment of inertia. How is the total potential energy of the beam affected?

It:

  1. Decreases
  2. Stays the same 
  3. Increases

 

Go to Step 3: Mesh

Proper Orientation

...

Line Sketching

...

Line Body

...

Cross Section

...

Merge the Cross Section with the Line Body

...

Verify Geometry

...

Exporting The Geometry to The Model

In order to make sure to get the geometry data transferred to the Model a couple of steps must be taken.  First, right click on "Geometry" then click on "Properties". Under "Properties of Schematic A3: Geometry" expand "Basic Geometry Options" and check the box to the right of "Line Bodies" as seen below.
Image Removed
Go to Step 3: MeshSee and rate the complete Learning Module

Go to all ANSYS Learning Modules