Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3
Panel

Author: Rajesh Bhaskaran & Yong Sheng Khoo, Cornell University

Problem Specification
1. Pre-Analysis & Start-up
2. Geometry
3. Mesh
4. Setup (Physics)
5. Solution
6. Results
7. Verification & Validation
Problem 1
Problem 2

...

Now we will set the solve settings for this problem and then solve using an iterative approximation process.

Under Solution  > Solution Methods

We'll just use the defaults. Note that a second-order Upwind scheme will be used. Click OK.

Set Initial Guess

Main Menu > Solve > Initialization

As you may recall from the previous tutorials, this is where we set the initial guess values for the iterative solution. We'll set these values to be the ones at the inlet, so under Compute From select inlet.This will automatically set the initial values for all the cells. You can also type the values by hand and the results will be equivalent.


Click Initialize. This completes the initialization.

...

FLUENT reports a residual for each governing equation being solved during the iterative process. The residual is a measure of how well the current solution satisfies the discrete form of each governing equation. We'll iterate the solution until the residual for each equation falls below 1e-6.

Main Menu > Solve > Monitors or Under Solution > Monitors  select  Residual > Edit

Change the residual under Convergence Criterion for continuity, x-velocity, y-velocity and energy to 1e-6.

Also, under Options select Plot if is not selected yet. This will plot the residuals in the graphics window as they are calculated.

Click OK.

Iterate Until Convergence

Main Menu > Solve > Run calculation or Under Solution > Run Calculation 

In the Iterate Window that comes up, change the Number of Iterations to 500. Click Calculate.

The residuals are printed out as well as plotted in the graphics window for each iteration.

Save the case and data after you have obtained a converged solution by going to File > Write > Case & Data

Go to Step 6: Results

See and rate the complete Learning Module

Go to all FLUENT Learning Modules