Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Let's create lines after heated section
Insert > Location > Line
Name it "Postheat 1" and click OK. On the lower left panel, you will see Details of Postheat 1. Enter the following coordinates.
Point 1 (4.27,0,0)
Point 2 (4.27,0.0294,0)
Enter 50 for Samples. (This will be the number of sample points used when plotting data) Click Apply.
Create Postheat 2.
Insert > Location > Line
Name it "Postheat 2" and click OK. On the lower left panel, you will see Details of Postheat 2. Enter the following coordinates.
Point 1 (5,0,0)
Point 2 (5,0.0294,0)
Enter 50 for Samples. Click Apply.
Continue the same step for creating line Outlet (x=6.096m)
Check that you have the following under Outline.

...

Insert > Chart 
Enter "Second Section Axial Velocity Profile" as Name. You will see Details of Second Section Axial Velocity Profile appear on the lower left panel. Under General, give the chart Title as "Axial Velocity Profile".


 
Now click on Data Series tap to specify the location of the chart data. Create a new data series.  Under Data Source, specify Preheat 3 as Location. Change the name to x=1.8m. Continue adding Data Source until we added all Preheat 3, Postheat 1, Postheat 2, and Outlet. Name them according to the figure shown below.
 
Now we will specify the X Axis parameter. Click on X Axis tab. Next to Variable, choose Y. Next we will specify the Y Axis parameter. Click on Y Axis tab. Next to Variable, choose Velocity. Click Apply. You will see First Section Axial Velocity Profile created under Report in the Outline tab.
This is what you should see in the Graphics window.

...