Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Wiki Markup
{alias:crank}
{panel}
Author: Rajesh Bhaskaran, Cornell University

{color:#ff0000}{*}Problem Specification{*}{color}
[1. Start-up and preliminary set-up|ANSYS 11 - Crank Step 1]
[2. Specify element type and constants|ANSYS 11 - Crank Step 2]
[3. Specify material properties|ANSYS 11 - Crank Step 3]
[4. Specify geometry|ANSYS 11 - Crank Step 4]
[5. Mesh geometry|ANSYS - Crank Step 5]
[6. Specify boundary conditions|ANSYS - Crank Step 6]
[7. Solve\!|ANSYS - Crank Step 7]
[8. Postprocess the results|ANSYS - Crank Step 8]
[9. Validate the results|ANSYS - Crank Step 9]
{panel}

h2. Problem Specification


h4.

A preeminent bicycle company is disappointed with the negative feedback they have received on their latest model, and they have pinpointed the problem to an outdated bicycle crank design that they assumed would still withstand typical loads. To protect their reputation, they have outsourced the task of analyzing the crank to you, providing you with the geometry of the bicycle crank and attached pedal shaft shown below. The dimensions are given in inches. The material they selected has an Young's modulus _E_=2.8x10{^}7^ psi and Poisson ratio _ν_=0.3. 

!crank.jpg!
{newwindow:Higher Resolution Image}https://confluence.cornell.edu/download/attachments/82384572/crankDiagram.jpg?version=1{newwindow}
Using ANSYS, determine the mechanical response due to a load of 100 lbf applied vertically downward at the end of the pedal shaft as shown in the figure below. Assume that the crank is attached rigidly to a fixed shaft fitted into the hole near the left end of the crank. This means you can constrain the surface of the left hole in _X_, _Y_ and _Z_ directions as indicated below.

!crank2.jpg!

Calculate the deflection, strain and stress distributions in the crank/pedal shaft combination for this loading condition. Use the ANSYS results to evaluate the degree of stress concentration in the vicinity of the cut-out in the crank geometry.

*[*Go to Step 1: Start-up and preliminary set-up*|ANSYS 11 - Crank Step 1]*

[See and rate the complete Learning Module|ANSYS 11 - Crank]

[Go to all ANSYS Learning Modules|ANSYS Learning Modules]