Section |
---|
Column |
---|
Stacked Rapid Sand Filtration |
|
Image Removed
Introduction
...
...
...
a novel self-backwashing filter invented by the AguaClara team. Its unique stacked geometry allows it to use the same flow rate for the filtration and backwash cycles, without the expensive pumps or elevated tanks required to backwash conventional rapid sand filters. In addition, a stacked filtration system requires a much smaller footprint |
|
...
than a conventional filter to treat a given flow rate. A vertically stacked filtration system meets many of the AguaClara Project constraints. Both normal filtration and |
|
...
backwash operations are gravity driven and require no electricity. In additon, it is an open system. The required construction materials (PVC pipes, sand, concrete, brick, and rebar) are relatively cheap and available in Honduras. Most importantly, stacked rapid sand filtration is proven to consistently lower the effluent to below |
|
...
Column |
---|
Image Added
Image Added
Image Added
|
|
For more information, please see the explanation of stacked rapid sand filtration theory and unit design and the General Filtration Page.
Learn about the Stacked Filtration Team and our Challenges.
Bench Scale Model
This is our current experimental apparatus.
Backwash
We need to prove the ability to clean the stacked rapid sand filter by backwashing. In order to prove backwashing works, we need to fully fluidize the filter and settle it to continue filtration.
Head Loss Measurement
The head loss across the filter over time is the governing factor that determines the filtration cycle time. The build up of head loss ultimately determines how often the filtration unit will require backwashing.
Filtration Unit Design
It is necessary to design a filtration unit that can be built at our existing water treatment plants and be incorporated into future plant designs. This includes a hydraulic analysis to calculate the critical elevations in relation to how the filter fits in with the sedimentation tank effluent weir and the distribution tank. This analysis must be done using the approach for the design tool with correctly named variables, and with the standard inputs of flow rate and then automated design of the filter system. This automated design must include full hydraulic design of all of the piping required.
Performance Study
A number of parameters will need to be studied in order to find the optimal design conditions for a filtration unit. The variables to be studied experimentally include diameter of sand grains, depth of each filter layer, horizontal spacing between pipes, and filtration velocity. A robust study of all these variables will require a long period of time, and it is thus recommended that we proceed with the design and installation of a filtration unit with conservative design parameters. Once full-scale performance can be analyzed, we can proceed with an exhaustive performance study to further optimize the stacked rapid sand filtration unit design.
Future Research
Field Scale Testing
We plan to build a stack rapid sand filter as an addition to an existing plant that uses AguaClara technology.
Past Research
Summer 2010 SRSF Research
Built initial bench scale model and initialized proof of concept.
...