Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column

Stacked Rapid Sand Filtration

Image Removed

Introduction

...

The stacked rapid sand

...

filter is

...

a novel self-backwashing filter invented by the AguaClara team. Its unique stacked geometry allows it to use the same flow rate for the filtration and backwash cycles, without the expensive pumps or elevated tanks required to backwash conventional rapid sand filters. In addition, a stacked filtration system requires a much smaller footprint

...

than a conventional filter to treat a given flow rate.

A vertically stacked filtration system meets many of the AguaClara Project constraints. Both normal filtration and

...

backwash operations are gravity driven and require no electricity. In additon, it is an open system. The required construction materials (PVC pipes, sand, concrete, brick, and rebar) are relatively cheap and available in Honduras. Most importantly, stacked rapid sand filtration is proven to consistently lower the effluent to below

...

the US EPA standard of 0.3 NTU.

Excerpt
Current Research

Low Flow SRSF

Low Flow Stacked Rapid Sand Filters are an adaptation of rapid sand filters optimized for flows less than 3 L/s that don't require any flow control or backwash.

Floc Filtration

Further Reading

Proof of Concept Paper
General Filtration
Current Challenges
Past Challenges

Column

Image Added

Image Added

Image Added

Section
Column
Current Members

Mihir Gupta
Kris LaPan
Rachel Proske
Nadia Shebaro

Column
Documents
Column
Past Research

Spring 2012 Full Scale
Spring 2012 Pilot Scale
Spring 2012 Bench Scale
Fall 2010
Summer 2010
Theory and Design
Spring 2010

For more information, please see the explanation of stacked rapid sand filtration theory and unit design and the General Filtration Page.

Keep up to date with Reflection Reports and Future Challenges for the Stacked Filtration Team!

Current Research

Bench Scale Model
This is our current experimental apparatus.

Backwash
We need to prove the ability to clean the stacked rapid sand filter by backwashing. In order to prove backwashing works, we need to fully fluidize the filter and settle it to continue filtration.

Head Loss Measurement
The head loss across the filter over time is the governing factor that determines the filtration cycle time. The build up of head loss ultimately determines how often the filtration unit will require backwashing.

Filtration Unit Design
It is necessary to design a filtration unit that can be built at our existing water treatment plants and be incorporated into future plant designs. This includes a hydraulic analysis to calculate the critical elevations in relation to how the filter fits in with the sedimentation tank effluent weir and the distribution tank. This analysis must be done using the approach for the design tool with correctly named variables, and with the standard inputs of flow rate and then automated design of the filter system. This automated design must include full hydraulic design of all of the piping required.

Performance Study
A number of parameters will need to be studied in order to find the optimal design conditions for a filtration unit. The variables to be studied experimentally include diameter of sand grains, depth of each filter layer, horizontal spacing between pipes, and filtration velocity. A robust study of all these variables will require a long period of time, and it is thus recommended that we proceed with the design and installation of a filtration unit with conservative design parameters. Once full-scale performance can be analyzed, we can proceed with an exhaustive performance study to further optimize the stacked rapid sand filtration unit design.

Future Research

Field Scale Testing
We plan to build a stack rapid sand filter as an addition to an existing plant that uses AguaClara technology.

Past Research

Summer 2010 SRSF Research
Built initial bench scale model and initialized proof of concept.

...