Include Page | ||||
---|---|---|---|---|
|
Include Page | ||||
---|---|---|---|---|
|
...
Numerical Results
The following video shows how to plot the deformed shape to check if our boundary conditions have been applied correctly.
SimCafe: Pressure Vessel in ANSYS, Results1
HTML |
---|
<iframe width="600" height="338" src="//www.youtube.com/embed/7GLabKnRr2I?rel=0" frameborder="0" allowfullscreen></iframe> |
The hoop, axial and radial stresses can be found in a similar fashion.
SimCafe: Pressure Vessel in ANSYS, Results2
HTML |
---|
<iframe width="600" height="338" src="//www.youtube.com/embed/jaoQMnjTos4?rel=0" frameborder="0" allowfullscreen></iframe> |
A really neat way to represent hoop stress graphically is by using the "path" “path” tool in ANSYS. The following video shows how to display stress as a function of radius much like the figure below.
SimCafe: Pressure Vessel in ANSYS, Results3
HTML |
---|
<iframe width="600" height="338" src="//www.youtube.com/embed/e6V7pTat0cM?rel=0" frameborder="0" allowfullscreen></iframe> |
The “path” The "path" tool can also be used to show the axial and radial stresses along the top edge. Try it!
The next video shows how to display the full 3d model by revolving the 2D section 360° about the y-axis. Note that it comes from it different project, but the steps are the same.
SimCafe: Pressure Vessel in ANSYS, Results4
HTML |
---|
<iframe width="600" height="338" src="//www.youtube.com/embed/_cvqjodZH7A?rel=0" frameborder="0" allowfullscreen></iframe> |
Go to Step 7: Continue to Step 7 - Verification and Validation