Include Page | ||||
---|---|---|---|---|
|
Include Page | ||||
---|---|---|---|---|
|
Geometry
Launch ANSYS Workbench: Start > All Programs > ANSYS > Workbench
Note |
---|
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler. |
Create Flow Domain
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/4O3nUq5Vzok?rel=0" frameborder="0" allowfullscreen></iframe> |
Imprint Lines to Control Mesh Sizing
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/cNMyaJB5hsU?rel=0" frameborder="0" allowfullscreen></iframe> |
Close Design Modeler and Save Project
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/j7ydNoeIt-0?rel=0" frameborder="0" allowfullscreen></iframe> |
Panel |
Author: John Singleton and Rajesh Bhaskaran Problem Specification1. Pre-Analysis & Start-Up 2. Geometry 3. Mesh 4. Setup (Physics) 5. Solution 6. Results 7. Verification and Validation Exercises |
Go to Step 3: Mesh
See and rate the complete Learning Module