This page has been moved to https://courses.ansys.com/index.php/courses/structural-analysis-of-a-trachea/
Click in the link above if you are not automatically redirected in 10 seconds.
Click in the link above if you are not automatically redirected in 10 seconds.
Include Page | ||||
---|---|---|---|---|
|
...
Trachea Analysis Problem Specification
Created using ANSYS 2020 R1
Learning Goals
In this tutorial, you will learn how to:
- Develop a CFD solution for wind turbine rotor using ANSYS Fluent
- Develop a a 3D mesh, solve for the flow field, and plot results
Problem Specification
...
This tutorial shows how to simulate deformation of a trachea under a pressure load. Dimensions and properties used in this tutorial are:
- 7 cartilage rings, each 300 degrees, thickness 1.1mm, width 5 mm, E = 2 MPa, Poisson's ratio = .3
- Tissue thickness 1 mm, width 10 mm, E = 20 kPa, Poisson's ratio = .3
- Trachea diameter of 20 mm
Steps to modify properties (to model tracheomalacia) and geometry (to model tracheotomy) are shown in the exercises.
Below is a summary of Ansys steps demonstrated in the videos
The following document lists the steps of this tutorial with general directions:
View file | ||||
---|---|---|---|---|
|
Go to Step 1: Pre-Analysis & Start-Up
Go to all ( ANSYS or FLUENT) Learning Modules