Include Page | ||||
---|---|---|---|---|
|
Include Page | ||||
---|---|---|---|---|
|
Geometry
Note |
---|
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler. |
Panel |
---|
Author: John Singleton and Rajesh Bhaskaran, Cornell University Problem Specification |
Modal ANSYS
2. Geometry
Modal (ANSYS) Project Selection
...
https://confluence.cornell.edu/download/attachments/145756992/CreateModalFull.png
...
https://confluence.cornell.edu/download/attachments/145756992/CreatedModal_Full.png
Rename Modal (ANSYS)
...
https://confluence.cornell.edu/download/attachments/145756992/PoperProjectNaming_Full.png
Attach Geometry from Cantilever to Cantilever Modal
The geometry for the "Cantilever Beam Modal Analysis" tutorial is the same as the geometry for the "Cantilever Beam" tutorial. Instead of recreating the geometry, we will simple attach the geometry from the Static Structural Analysis System (Cantilever) to the Modal Analysis System (Cantilever Modal). In order to attach the geometry, (left click geometry ) Geometry in the "Cantilever" project and drag it to geometry Geometry in the "Cantilever Modal" project, as shown below.
newwindow | ||||
---|---|---|---|---|
| ||||
https://confluence.cornell.edu/download/attachments/145756992/ShareGeometry_Full.png |
Then release the left mouse button. You should now see that the geometries are shared as shown in the following image.
newwindow | ||||
---|---|---|---|---|
| ||||
https://confluence.cornell.edu/download/attachments/145756992/SharedGeometry_Full.png |
Save
Go to Step 3: Mesh
See and rate the complete Learning Module