Include Page | ||||
---|---|---|---|---|
|
Include Page | ||||
---|---|---|---|---|
|
Geometry
Launch ANSYS Workbench: Start > All Programs > ANSYS > Workbench
Note |
---|
For users of ANSYS 15.0, please check this link for procedures for turning on the Auto Constraint feature before creating sketches in DesignModeler. |
Create Flow Domain
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/4O3nUq5Vzok?rel=0" frameborder="0" allowfullscreen></iframe> |
Imprint Lines to Control Mesh Sizing
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/cNMyaJB5hsU?rel=0" frameborder="0" allowfullscreen></iframe> |
Close Design Modeler and Save Project
HTML |
---|
<iframe width="560" height="315" src="https://www.youtube.com/embed/j7ydNoeIt-0?rel=0" frameborder="0" allowfullscreen></iframe> |
Panel |
---|
Author: John Singleton and Rajesh Bhaskaran Problem Specification |
Note |
---|
Under Construction: Please go to Step 3 to download the geometry and mesh files. |
2. Geometry
Fluid Flow(FLUENT) Project Selection
Drag Fluid Flow(FLUENT) into the Project Schematic window.
Analysis Type
(Right Click) Geometry > Properties
Set Analysis Type to 2D
Launch Design Modeler
(Double Click) Geometry
Create Two Concentric Circles and Dimension
Create two concentric circles, centered around the origin in the xy plane. Set the diameter of the inner circle to 1m and set the diameter of the outer circle to 64 m.
...
Go to Step 3: Mesh
See and rate the complete Learning Module