Include Page |
---|
...
|
...
|
4. Setup (Physics)
Fix The Two Supports
...
Create The Two Point Loads
...
Include Page | ||||
---|---|---|---|---|
|
Physics Setup
Assign the Young's modulus. Apply the boundary conditions and make sure the structure is well-constrained to prevent motion in x,y,z.
Widget Connector | ||||||
---|---|---|---|---|---|---|
|
...
Create The Two Distributed Loads
The middle 2kN/m distributed load will be created first. Right click on "Static Structural", then click "Insert", then click "Line Pressure" as shown below.
Now, click on the line selection button, , and select the lower horizontal line (it should highlight green). Then, click the apply button in the "Details of Line Force" box. Next, change "Define By" to "Components" as was done earlier. Set the y component to -2000N/m as shown below.
Go to Step 5: SolutionSee and rate the complete Learning ModuleNumerical Solution