Page History

...

Although there is no analytical solution for a finite plate with a hole, there is empirical data available to find a concentration factor. Using a Concentration Factor Chart (Cornell 3250 Students: See Figure 4.22 on page 158 in Deformable Bodies and Their Material Behavior), we find that d/w = 1 and thus K ~ 2.73. Now, we can find the maximum stress using the nominal stress and the concentration factor:

Start-Up

A few words on the formatting on the following instructions:

1. Notes that require you to perform an action are colored in blue

2. General information is colored in black, but does not require any action

3. Words that are bolded are labels for items found in ANSYS AIM

4. Most important notes are colored in red

Now that we have the pre-calculations, we are ready begin simulating in ANSYS AIM. Open ANSYS AIM by going to Start > All Apps > ANSYS 18.1 > ANSYS AIM 18.1. Once you are at the start page of AIM, select the Structural template in the top left corner as shown below.

...